Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Automatic Door Locks System Check performed?
| --
| Go to
Step 2
| Go to
Automatic Door Locks System Check
|
2
| Did you perform the BCM diagnostic system check?
| --
| Go to
Step 3
| Go to
Diagnostic System Check - Body Control System
in Body Control System
|
3
|
- Turn the ignition switch to the RUN position.
- Lower all of the vehicle windows. Ensure that the windows are
completely lowered.
- Insert the key in the ignition key lock cylinder.
- Leave the ignition switch in the OFF position.
- Open the driver's door.
- Observe the door locks and momentarily press LOCK on the door
lock switch.
- Close the driver's door.
- Open the left rear door.
- Reach through the driver's window opening. Observe the door locks
and momentarily press LOCK on the door lock switch.
- Open the right front door.
- Observe the door locks and momentarily press LOCK on the door
lock switch.
- Close the right front door.
- Open the right rear door.
- Reach through the right front window opening. Observe the door
locks and momentarily press LOCK on the door lock switch.
- Determine if all of the doors lock when the following conditions
exist:
• | You press LOCK on either door lock switch. |
• | The key is in the ignition key lock cylinder. |
Do the door locks operate as described above?
| --
| Go to
Step 4
| Go to
Step 5
|
4
|
- Open the driver's door.
- Fully insert the key into the ignition key lock cylinder.
- Leave the ignition switch in the OFF position.
- Observe the door locks. Press the driver's door lock switch. Hold
the driver's door lock switch for 3 seconds.
- Use the driver's door lock switch in order to unlock the doors.
- Close the driver's door.
- Open the right front door.
- Observe the door locks. Press the passenger's door lock switch.
Hold the passenger's door lock switch for 3 seconds.
- Determine if all of the doors lock when the following conditions
exist:
• | You hold the lock on either door lock switch for 3 seconds. |
• | The key is in the ignition. |
Do the door locks operate as described above?
| --
| Go to
Step 6
| Go to
Step 7
|
5
| The lockout prevention feature is malfunctioning. Refer to
Power Door Locks Lockout Mode Inoperative
.
Is the repair complete?
| --
| Go to
Step 8
| --
|
6
| The lockout prevention feature is operating normally. Refer to
Automatic Door Lock Circuit Description
.
Is the repair complete?
| --
| Go to
Step 8
| --
|
7
|
- Inspect the BCM connectors for poor terminal contact.
- If the BCM connectors do not exhibit poor terminal contact, replace
the BCM. Refer to
Body Control Module Replacement
in Body
Control System.
Is the repair complete?
| --
| Go to
Step 8
| --
|
8
|
- Turn the ignition switch to the OFF position.
- Reconnect all of the connectors.
- Install any components that you removed.
- Turn the ignition switch to the RUN position for 6 seconds.
- Turn the ignition switch to the OFF position.
- Remove the MALL PGM fuse.
- Turn the ignition switch to the ACC position.
The BCM sounds the chime a number of times equivalent to the BCM type
installed in the vehicle.
- Within 1 second, turn the ignition switch from the ACC
position to the OFF position and back to the ACC position. The BCM sounds
any stored DTCs.
Are there any BCM DTCs present?
| --
| Go to
Diagnostic System Check - Body Control System
in Body Control System
| Go to
Automatic Door Locks System Check
|