Important: When reusing the window weatherstrip, the flange mounting area (1)
must be pinched together to counteract the splaying effect when removed. Use
thumb and index finger to pinch the carrier (2) back together.
Work from one end of the weatherstrip to the other.
- Install the rear door stationary window into the door frame.
| 1.1. | Seat the stationary window back, into the door frame. |
| 1.2. | Insert the window weatherstrip into the door frame. |
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the division post fastener (1).
Tighten
Tighten the division post fastener to 9 N·m (80 lb in).
- Install the rear door window. Refer to
Rear Side Door Window Replacement
.
- Install the rear door window outer belt molding. Refer to
Rear Door Window Belt Outer Sealing Strip Replacement
.
- Install the rear door window inner belt molding. Refer to
Rear Door Window Belt Inner Sealing Strip Replacement
.
- Install the energy absorber pad. Refer to
Rear Door Energy Absorber Pad Replacement
.
- Install the water deflector. Refer to
Rear Side Door Water Deflector Replacement
.
- Install the door module. Refer to
Door Control Module Replacement
.
- Install the door trim panel. Refer to
Rear Side Door Trim Panel Replacement
.
