Turn Signal Switch Housing - Assemble - Off Vehicle Telescoping Column

Important: The switch mounting bracket must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly screws to line up.

1. Slide the turn signal switch housing onto the steering column.

Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

2. Slide the windshield wiper and washer switch assembly into the signal switch housing. Refer to Windshield Wiper and Washer Switch Assembly - Assemble - Off Vehicle .
3. Install the turn signal and multifunction switch assembly only. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle .
4. Install the steering column tilt head components. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .
5. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.