Windshield Wiper and Washer Switch Assembly - Assemble - Off Vehicle Telescoping

1. Slide the windshield wiper and washer switch assembly into the bracket until the clips engage.




Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

2. Route the wire harness assembly along the steering column jacket assembly.
3. Connect the windshield wiper and washer switch assembly connector, if necessary.



4. Install the wire harness strap (2) to the steering column tilt head assembly (1).
5. Install the wire harness strap (2) to the wire harness assembly.



6. Pop the wire harness assembly (1) into the wire harness strap (2).
7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
8. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.

Windshield Wiper and Washer Switch Assembly - Assemble - Off Vehicle Non-Telescoping

1. Slide the windshield wiper and washer switch assembly into the bracket until the clips engage.



2. Route the wire harness assembly along the steering column jacket assembly.
3. Connect the windshield wiper and washer switch assembly connector, if necessary.



4. Pop the wire harness assembly (1) into the wire harness strap (2).



5. Install the wire harness straps (2) to the steering column tilt head assembly (1).
6. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
7. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.