Memory Seat Programming
Perform the following actions in order to program the memory seats
for 3 separate drivers:
- Move the seat, the outside mirrors, and the automatic day/night
rearview mirror to the desired position.
- Press and hold the memory set (M) switch and the desired memory
switch (1, 2, or 3) simultaneously for approximately 5 seconds. A
chime should be heard when the settings are programmed.
- Repeat the steps for the second driver and the third driver.
Programmable Automatic Door Locks
To Enter Programming Mode
With the ignition On, the transmission in PARK (P) and the brake pedal
pressed down, you are now ready to begin programming the Remote Keyless Entry
transmitter number 1.
| • | All doors do not UNLOCK when shifting into PARK (P). |
| • | All doors UNLOCK when shifting into PARK (P). |
| | To toggle
between the above two settings, Press the UNLOCK button on the remote keyless
entry transmitter 4 times. Each press should be held for about
1 second with less than 5 seconds in between each press. |
| • | All doors do not LOCK when shifting out of PARK (P). |
| • | All doors LOCK when shifting out of PARK (P). |
| | To toggle
between the above two settings, Press the LOCK button on the remote keyless
entry transmitter 4 times. Each press should be held for about
1 second with no more than 5 seconds in between each press. |
| • | Repeat the above procedures to program the remote keyless entry
transmitter number 2. |
Additional Information
For more information on memory seats, refer to
Memory Seats Description and Operation
in Seats.
For more information on outside mirrors, refer to
Outside Mirror Description and Operation
in Doors.
For more information on automatic day/night rearview mirror, refer to
Inside Rearview Mirror Description and Operation
in Stationary Windows.
For more information on the Programmable Automatic Door Locks, refer
to
Keyless Entry System Description and Operation
in Keyless Entry.
