Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Wiper/Washer Connector End Views DEFINITION: This table diagnoses the wipers operate normally but will not return to the park position when the wiper operation is cancelled. | |||
1 | Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? | Go to Step 2 | |
2 |
Do the front wipers advance to the park position? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Do the wipers park? | Go to Step 8 | Go to Step 4 |
4 | Check for wiper motor bracket and crank arm damage. Was damage found? | Go to Step 5 | |
5 | At the wiper/washer switch connector, measure the voltage of the windshield wiper switch signal 2 circuit. Does the voltage measure greater than 1.0 volts? | Go to Step 6 | Go to Step 9 |
6 |
Does the voltage measure greater than 1.0 volts? | Go to Step 7 | Go to Step 9 |
7 | Repair a short to battery positive voltage in the windshield wiper switch signal 2 circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 10 | -- |
8 | Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt. Did you complete the replacement? | Go to Step 10 | -- |
9 | Replace the wiper motor cover. Refer to Windshield Wiper Motor Cover Replacement . Did you complete the replacement? | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
