Step
| Action
| Value(s)
| Yes
| No
|
1
| Has the starting system check been performed?
| --
| Go to
Step 2
| Go to
Starting System Check
|
2
| Load test the battery. Refer to
Battery Check
.
Does the battery pass the Battery Load Test?
| --
| Go to
Step 3
| Go to
Battery Replacement
|
3
|
- Turn the ignition switch to the OFF position.
- Connect J 39200
between the positive battery terminal and the starter terminal B.
- While measuring voltage on the DMM, turn the ignition switch to
the START position.
Is the voltage measured less than the specified value?
| 0.5 V
| Go to
Step 4
| Go to
Step 6
|
4
|
- Connect a DMM between the negative battery terminal and G113.
- While measuring voltage on the DMM, turn the ignition switch to
the START position.
Is the voltage measured less than the specified value?
| 0.5 V
| Go to
Step 5
| Go to
Step 7
|
5
| Inspect for
engine seizure.
Does the engine show signs of seizure?
| --
| Go to
Step 8
| Go to
Step 9
|
6
|
- Inspect the positive battery cable (CKT 1) for a poor connection
between the starter motor terminal B and the battery.
- If connection is OK, then replace the positive battery cable.
Refer to
Battery Cable Replacement
or
Battery Cable Replacement
.
- Recheck the system.
Is the repair complete?
| --
| Go to
Step 10
| --
|
7
|
- If connection is OK, then replace the negative battery cable.
Refer to
Battery Cable Replacement
or
Battery Cable Replacement
.
- Recheck the system.
Is the repair complete?
| --
| Go to
Step 10
| --
|
8
| Refer to
Engine Component Description
.
Recheck the system.
Is the repair complete?
| --
| Go to
Step 10
| --
|
9
|
- Replace the starter. Refer to
Starter Motor Replacement
or
Starter Motor Replacement
.
- Recheck the system.
Is the repair complete?
| --
| Go to
Step 10
| --
|
10
|
- Turn the ignition switch to the OFF position.
- Reconnect connectors/components that were removed.
- Recheck the system.
Is the repair complete?
| --
| Go to
Starting System Check
| --
|
