Removal Procedure
- Open the transmitter case (6, 4).
| 1.1. | Insert a small flat-bladded tool between the 2 halves of the transmitter
case (6, 4) at the slot provided near the key ring hole (5). |
| 1.2. | Twist the tool in order to open the case. |
- Remove the battery (2).
Installation Procedure
- Install the battery (2).
- Use a 3-volt CR2032 battery or the equivalent.
- Install the battery with the positive side down.
- Close the transmitter case (6, 4).
- Ensure that the seal is in position. Align the 2 halves
of the case (6, 4) and snap the halves together.
- Verify the operation of the transmitter.
- A malfunctioning transmitter may need resynchronization. Refer
to
Transmitter Synchronization
.
- The normal battery life is approximately 2 years. Replace the
batteries when the range of the transmitter begins to decrease to less than
approximately 7 meters (23 ft).
