GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 G8 🢒 Preface 🢒 Dangers, Warnings, and Cautions 🢒 Rear Bumper Fascia Reflector Replacement

Removal Procedure
  1. Remove rear bumper fascia molding. Refer to Rear Bumper Fascia Molding Replacement.

    2. Object Number: 2128113 Size: SH
  2. Remove the rear bumper fascia molding to rear bumper fascia reflector retaining screw (4).

    3. Note: Care should be taken not to damage the rear bumper fascia reflector retaining clip (2)

  3. Remove the rear bumper fascia reflector (1) from the rear bumper fascia molding (3).

Installation Procedure

    Object Number: 2128113 Size: SH

    Note: Make sure that the rear bumper fascia reflector retaining clip (2) engages the rear bumper fascia molding (3).

  1. Install the rear bumper fascia reflector (1) to the rear bumper fascia molding (3).

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the rear bumper fascia molding to rear bumper fascia reflector retaining screw (4) and tighten to 20 N·m (18 lb. ft).
  3. Install the rear bumper fascia molding. Refer to Rear Bumper Fascia Molding Replacement.