Removal Procedure
- Remove the power seat adjuster mechanism. Refer to Power Seat Adjuster Mechanism Replacement .
- Place the adjusters in a bench vise.
- Remove the rear adjuster nut (1).
- Open the vise slowly in order to relieve the assist spring compression.
- Remove the adjuster from the vise.
- Remove the vertical assist spring (4).
- Remove the front adjuster nut (8).
- Remove the bolts (6) from the adjuster horizontal actuator (7).
- Remove the adjuster horizontal actuator (7).
Installation Procedure
- Install the adjuster horizontal actuator (7).
- Install the bolts (6) to the adjuster horizontal actuator (7).
- Install the vertical assist spring (4).
- Install the front adjuster nut (8).
- Place the adjuster into a bench vise.
- Carefully compress the vertical assist spring (4).
- Install the rear adjuster nut (1).
- Remove the adjuster from the bench vise.
- Install the power seat adjuster mechanism. Refer to Power Seat Adjuster Mechanism Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 2.4 N·m (21 lb in).
Tighten
Tighten the nut to 5 N·m (44 lb in).
Tighten
Tighten the nut to 5 N·m (44 lb in).
