Caution: Refer to SIR Handling Caution in the Preface section.

Important: Do not remove the steering column in order to replace the hazard warning switch. Refer to Steering Column Replacement .




1. Remove the bolt/screw (4).
2. Remove the button (3).
3. Remove the spring (2).
4. Remove the knob (1).

1. Install the knob (1).
2. Install the spring (2).
3. Install the button (3).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the bolt/screw (4).

Tighten
Tighten the bolt/screw to 0.7 N·m (6 lb in).