Tools Required

J 21177-A Drum-to-Brake Shoe Clearance Gage

1. Remove the rear caliper bracket. Refer to Rear Brake Caliper Bracket Replacement .
2. Remove the rotor. Refer to Rear Brake Rotor Replacement .
3. Loosen the adjusting nut on the parking brake cable until the lever is at the rest position. Refer to Park Brake Cable Service/Adjustment



4. Set the J 21177-A so that the J 21177-A contacts the inside diameter of the rotor.



5. Position the J 21177-A over the shoe and lining at the widest point.



6. Turn the adjuster nut (5) until the lining just contacts the J 21177-A .
7. Repeat steps two through five for the opposite side.
8. Adjust the adjusting nut on the rear parking brake cable. Refer to Park Brake Cable Service/Adjustment .

1. Tighten the parking brake cable adjusting nut. Refer to Park Brake Cable Service/Adjustment .
2. Install the rear rotor. Refer to Rear Brake Rotor Replacement .
3. Install the rear caliper bracket. Refer to Rear Brake Caliper Bracket Replacement .