The PCM has the ability to disable cruise control if conditions are detected which would make cruise control operation undesirable. The following conditions may cause cruise control to be inhibited by the PCM:
• | Engine not running long enough for cruise control operation. |
• | Transaxle range switch indicates park, neutral, low, or reverse gear selected. |
• | Engine speed is too high or too low. |
• | Vehicle speed is too high or too low. |
• | ABS system is active for longer than 2 seconds. |
• | Vehicle acceleration or deceleration rate is too high. |
If any of these conditions are present, the PCM will interrupt the ground on the cruise inhibit circuit to request that cruise control be disengaged. If the cruise status signal indicates that cruise control is still engaged while the PCM is inhibiting cruise control operation, DTC P1554 will be set.
• | The PCM is commanding the SMCC module to inhibit cruise control operation (Cruise Inhibit circuit not grounded). |
• | The Cruise Status circuit signal indicates that cruise control is engaged. |
• | The above conditions are present for longer than 1 second. |
• | The PCM will not illuminate the Malfunction Indicator Lamp (MIL). |
• | The PCM will store conditions which were present when the DTC set as Fail Records data only. This information will not be stored as Freeze Frame data. |
• | A history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction. |
• | DTC can be cleared by using the scan tool Clear Info function or by disconnecting the PCM battery feed. |
Check for the following conditions:
• | Poor connection at the PCM. |
Inspect harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection. |
• | Damaged harness. |
Inspect the wiring harness for damage. If the harness appears to be OK, observe the Cruise Status display on the scan tool while moving connectors and wiring harnesses related to the Stepper Motor Cruise Control module. A change in the display will indicate the location of the malfunction. |
If DTC P1554 cannot be duplicated, the information included in the Failure records data can be useful in determining how many ignition cycles have passed since the DTC was last set.
Number(s) below refer to the step number(s) on the Diagnostic Table.
Step | Action | Value(s) | Yes | No |
---|---|---|---|---|
1 | Was the Powertrain On-Board Diagnostic (OBD) System Check performed? | -- | ||
2 | Is DTC P1662 also set? | -- | ||
3 |
Is voltage greater than the specified value? | 7V | ||
4 |
Is the test light ON? | -- | ||
5 |
Is the test light on? | -- | ||
6 | Replace the cruise control module. Refer to On-Vehicle Service in Cruise Control. Is action complete? | -- | -- | |
Replace the PCM. Important:: The replacement PCM must be programmed. Refer to Powertrain Control Module Replacement/Programming . Is action complete? | -- | -- | ||
8 | Locate and repair short to ground in the cruise inhibit circuit. Refer to Repair Procedures in Wiring Repairs . Is action complete? | -- | -- | |
9 |
Did DTC P1554 set? | -- | System OK |