Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 | Check the washer solvent container fluid level. Is the washer solvent container filled? | -- | Go to Step 4 | Go to Step 3 |
3 | Fill the washer solvent container. Is the washer solvent container filled? | -- | -- | |
4 | Check the hoses to ensure that they are correctly attached and that they are not pinched or kinked. Are the hoses OK? | -- | Go to Step 6 | Go to Step 5 |
5 | Repair the hoses. Is the repair complete? | -- | -- | |
6 | Check for clogged windshield washer nozzles. Are the nozzles clogged? | -- | Go to Step 7 | Go to Step 8 |
7 | Repair the clogged nozzles. Is the repair complete? | -- | -- | |
8 | Check for a blown (open) wiper/washer fuse. Is the fuse blown (open)? | -- | Go to Step 9 | Go to Step 10 |
9 | Replace the blown (open) fuse. Is the replacement complete? | -- | -- | |
10 |
Is the test light on? | -- | Go to Step 11 | Go to Step 14 |
11 | Check for a poor connection condition at the washer pump connector. Is a poor connection condition present? | -- | Go to Step 12 | Go to Step 13 |
12 | Repair the poor connection condition. Is the repair complete? | -- | -- | |
13 | Replace the washer pump. Refer to Washer Pump Replacement . Is the replacement complete? | -- | -- | |
14 |
Is the test light on? | -- | Go to Step 15 | Go to Step 18 |
15 | Check for a poor connection condition or open circuit condition in CKT 227. Is a poor connection condition or open circuit condition present? | -- | Go to Step 16 | Go to Step 17 |
16 | Repair the poor connection condition or open circuit condition Is the repair complete? | -- | -- | |
17 | Replace the wiper motor (internal ground circuit open). Refer to Windshield Wiper Motor Replacement . Is the replacement complete? | -- | -- | |
18 |
Is the test light on? | -- | Go to Step 19 | Go to Step 20 |
19 | Repair the poor connection condition or open circuit condition in CKT 228. Is the repair complete? | -- | -- | |
20 |
Is the measurement within the specified range? | 10.5-15 volts | Go to Step 21 | Go to Step 24 |
21 | Check for a poor connection at connectors C201 and C219, or for an open circuit condition in CKT 94. Is a poor connection condition or open circuit condition present? | -- | Go to Step 22 | Go to Step 23 |
22 | Repair the poor connection condition or open circuit condition. Is the repair complete? | -- | -- | |
23 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | -- | |
24 | Replace the wiper/washer switch assembly. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column - Tilt. Is the replacement complete? | -- | -- |
