Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference : Radio/Audio System Schematics | ||||
1 | Did you perform the Radio/Audio System Diagnostic System Check? | -- | Go to Step 2 | |
2 | Operate all of the steering wheel controls. Do all of the steering wheel controls operate properly? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Test the radio on signal circuit for a short to ground or open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 4 |
4 |
Caution: When you are performing service on or near the SIR components or the SIR wiring, you must disable the SIR system. Refer to Disabling the SIR System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
Are the measured resistances approximately equal to the specified values? | Volume Up: 1.2K ohms Volume Down: 1.56K ohms Mode: 1.9K ohms Mute: 2.38K ohms Seek Up: 3.1K ohms Seek Down: 4.28K ohms AM/FM: 6.65K ohms Pre-Set: 13.6K ohms | Go to Step 5 | Go to Step 7 |
5 | Test the steering wheel controls signal circuit for a short, high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 6 |
6 | Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 9 |
7 | Inspect for poor connections at the harness connector of the steering wheel radio controls. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 8 |
8 | Replace the appropriate steering wheel radio control. Refer to Steering Wheel Control Switches Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
9 | Replace the Radio and perform the set up procedure for the Radio. Refer to Radio Replacement and Radio Setup . Did you complete the replacement? | -- | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
