Circuit Description
When the ignition switch is turned to ON, the sensing and diagnostic module (SDM) will perform turn-on test to diagnose critical malfunctions within SDM itself.
Upon passing these test ignition and deployment loop voltages are measured to ensure that they are within their normal voltage ranges. The SDM monitors the voltages at the driver low and the passenger low to detect shorts to ground or voltage in the deployment loops.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1405 RF Side Impact Sensor Short to Battery
Conditions for Running the DTC
Ignition voltage is within the normal operating voltage range.
Conditions for Setting the DTC
| • | The side impact sensor wiring of the passenger high is shorted to battery wiring. |
| • | The side impact sensor wiring of the passenger low is shorted to battery wiring. |
Action Taken When the DTC Sets
The SDM commands the AIR BAG indicator ON.
Conditions for Clearing the DTC
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: SIR Schematics Connector End View Reference: SIR Connector End Views Caution: Refer to Sensing and Diagnostic Module Handling Caution in the Preface section. Caution: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution in the Preface section. | ||||
1 | Did you perform a Diagnostic System Check - Vehicle? | Go to Step 2 | ||
2 |
Has the SDM discharged? | -- | Go to Step 3 | -- |
3 | Visually inspect for any damage on the passenger side impact sensor wiring and the connector. Are the passenger side impact sensor wiring and connector OK? | -- | Go to Step 5 | Go to Step 4 |
4 | Connect the connector or repair the damage. Did you complete the action? | -- | Go to Step 9 | -- |
5 | Measure the resistance between the high, low wiring of the passenger side impact sensor harness connector and battery positive. Is the resistance equal to the specified value? | 10K ohms | Go to Step 6 | Go to Step 8 |
6 |
Is the DTC removed? | -- | Go to Step 9 | Go to Step 7 |
7 | Replace the passenger side impact sensor. Refer to Inflatable Restraint Side Impact Sensor Replacement . Is the replacement complete? | -- | Go to Step 9 | -- |
8 | Replace the air bag wiring. Is the replacement complete? | -- | Go to Step 9 | -- |
9 |
Does the DTC reset? | Go to Step 2 | System OK | |
