DIC Warning Message
| Possible Cause
| Solution
|
|
Important: This diagnostic table is to be used only in conjunction with other diagnostic procedures in this section. Using this diagnostic table without being directed to its use, may result in the misdiagnoses of the power folding
top system.
|
ATTACH TRUNK PARTITION
|
| • | Luggage barrier not in place |
| • | Luggage barrier switch circuitry |
| • | Open luggage barrier switch |
|
| • | Install the luggage barrier. |
| • | Repair open in the switch supply voltage circuit |
| • | Repair open in the switch signal circuit |
| • | Replace luggage barrier switch |
| • | Replace folding top control module |
|
CLOSE TRUNK TO MOVE TOP
|
| • | Trunk ajar switch circuitry |
| - | Open in the switch supply voltage circuit |
| - | Open or a short to ground in the switch signal circuit |
| Refer to
Trunk Ajar Indicator Always On
|
SET PARK BRAKE TO MOVE TOP
|
| • | Park brake switch circuitry |
| - | Open in the park brake switch ground circuit |
| - | Open in the park brake switch signal circuit |
| Refer to
Brake Warning Indicator Inoperative
|
SHIFT TO PARK TO MOVE TOP
|
| • | Gear shift mode switch circuitry |
| - | Open in the gear shift mode switch ground circuit. |
| - | Open in the park/neutral signal circuit |
| Refer to
Starter Solenoid Does Not Click
|
TOP MOTOR OVER TEMPERATURE
|
| • | Internal short in the folding top pump motor |
| • | Folding top pump motor temperature sensor circuitry |
| Refer to
Diagnostic System Check - Vehicle
|
TOP NOT SECURE
|
| • | Tonneau latch circuitry |
|
| • | Repair the short to ground in the folding top cover ajar signal circuit. |
| • | Short to B+ in the control circuit of the folding top cover latch. |
| • | Open in the circuitry of the pin receiver switch. |
| • | Open in the circuitry of the top open switch. |
|
TOO COLD TO MOVE TOP
|
| • | Folding to pump motor temperature sensor |
| • | Folding top pump motor temperature sensor circuitry |
| Refer to
Diagnostic System Check - Vehicle
|
UNLATCH HEADER TO MOVE TOP
|
| • | Pin receiver switch circuitry |
|
| • | Repair the short to voltage in the folding top connected signal circuit. |
| • | Replace the pin receiver switch. |
|
