Electronic Column Lock Module - Assemble - Off Vehicle Telescoping Column
- Install the electric column lock (2) to the steering column tilt head assembly.
- Install the 3 pan head tapping screws (1).
- Slide the windshield wiper and washer switch assembly into the electric column lock until the clips engage.
- Route the wire harness assembly along the steering column jacket assembly.
- Connect the connector, if necessary.
- Install the wire harness strap (2) to the steering column tilt head assembly (1).
- Install the wire harness strap (2) onto the wire harness assembly.
- Pop the wire harness assembly (1) into the wire harness strap (2).
- Install the steering column tilt head housing. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
Electronic Column Lock Module - Assemble - Off Vehicle Non-Telescoping Column
- Install the electric column lock to the steering column tilt head assembly.
- Install the 2 pan head tapping screws.
- Slide the windshield wiper and washer switch assembly into the electric column lock until the clips engage.
- Connect the electric lock module connector.
- Route the wire harness assembly along the steering column jacket assembly.
- Connect the connector, if necessary.
- Install the wire harness strap (2) to the steering column tilt head assembly (1).
- Install the wire harness strap (2) onto the wire harness assembly.
- Pop the wire harness assembly (1) into the wire harness strap (2).
- Install the steering column tilt head housing. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
