Step | Action | Value(s) | Yes | No | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
DEFINITION: The SECURITY indicator is ON (or flashing) at all times or is inoperative. | ||||||||||||||||||
1 | Were you sent here from the Theft Deterrent Diagnostic System Check? | -- | ||||||||||||||||
2 | Using a scan tool, try to establish communications with the BCM, LDCM, RDCM, and PCM systems. Can the scan tool communicate with the BCM, IPC, LDCM, RDCM, and PCM systems? | -- | ||||||||||||||||
3 | Using a scan tool, select IPC Special Functions and command the SECURITY indicator ON and OFF. Does the SECURITY indicator turn ON and OFF with each command? | -- | ||||||||||||||||
4 | Using the power door lock switches, operate the driver and passenger door locks. Do the power door locks operate correctly? | -- | ||||||||||||||||
5 |
Is the door ajar message displayed? | -- | ||||||||||||||||
6 | Open the driver door. Is the door ajar message displayed? | -- | ||||||||||||||||
7 |
Is the door ajar message displayed? | -- | ||||||||||||||||
8 | Turn ON the ignition switch. Is the SECURITY indicator ON or flashing? | -- | ||||||||||||||||
9 | Inspect the following circuits for an intermittent malfunction
Was a problem found and repaired? | -- | ||||||||||||||||
10 | Repair the no communication malfunction to the system that could not communicate with the scan tool. Refer to the appropriate Diagnostic System Check that applies to the system that did not communicate. Is the repair complete? | -- | -- | |||||||||||||||
11 | Using a scan tool, check any DTC that affect theft deterrent performance. Refer to Diagnostic Trouble Code (DTC) List/Type . Are any of these DTC stored? | -- | ||||||||||||||||
12 |
Is the repair complete? | -- | -- | |||||||||||||||
