Were you sent here from the Indicator System Check?

--

Go to Step 2

Go to Indicator System Check

1. Turn ON the ignition switch.
2. Using a scan tool, attempt to establish communications with the IPC.

Does the scan tool communicate with the IPC?

--

Go to Step 3

Go to Diagnostic System Check - Instrument Cluster

Is a DTC B1532 stored in the IPC?

--

Go to the Applicable Table

Go to Step 4

Press and release the E/M button on the RH DIC switch to toggle between English and Metric display.

Does the km/h and MPH indicator turn ON and OFF?

--

System OK

Go to Step 5

Using a scan tool, select IPC special functions and turn ON and OFF the km/h and MPH indicator.

Does the km/h and MPH indicator turn ON and OFF?

--

Go to Step 6

Go to Step 8

Check for an open in the RH DIC switch harness, between the DIC switch and the IPC.

Was a problem found and repaired?

--

Go to Step 10

Go to Step 7

Replace the RH DIC switch assembly. Refer to Driver Information Display Switch Replacement .

Is the replacement complete?

--

Go to Step 10

--

Check the km/h and MPH indicator bulb for an open. Refer to Instrument Cluster Indicator Lamp Replacement .

Was a problem found and repaired?

--

Go to Step 10

Go to Step 9

Replace the IPC assembly. Refer to Instrument Cluster Replacement .

Is the replacement complete?

--

Go to Step 10

--

1. Turn OFF the ignition switch.
2. Reconnect or install any connectors or components that were disconnected or removed.
3. Turn ON the ignition switch.

Is the repair complete?

--

Go to Indicator System Check

--