Removal Procedure
- Remove the fuel filler cap.
- Remove the left rear wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Rear End.
- Disconnect the fuel fill hose (3) and the vent hose (4) from the fuel tank fill and vent pipe (1).
- Cap the open ends of the fuel fill hose (3) and the vent hose (4).
- Disconnect the fuel system ground strap.
- Remove the fuel tank fill and vent pipe from the fuel filler pocket.
Installation Procedure
- Install the fuel tank fill and vent pipe to the fuel filler pocket.
- Connect the fuel fill pipe ground strap.
- Uncap the openings on the fuel fill hose (3) and the vent hose (4).
- Connect the fuel fill hose (3) and the vent hose (4) to the fuel tank fill and vent pipe (1).
- Install the left rear wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Rear End.
- Install the fuel filler cap.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fuel tank fill and vent pipe bolts to 2.5 N·m
(22 lb in).
Tighten
Tighten the fuel fill pipe ground strap bolt to 8 N·m (71 lb
in).
Tighten
Tighten the fuel fill hose clamp and the vent hose clamp to 4 N·m
(35 lb in).
