GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Corvette 🢒 Body and Accessories 🢒 Body Rear End 🢒 Wheelhouse Panel Replacement

Removal Procedure
  1. Remove the rear tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

    2. Object Number: 71250 Size: SH
  2. Remove the bolts attaching the rear wheelhouse liner panel.
  3. Remove the wheelhouse liner panel.

Installation Procedure

    Object Number: 71250 Size: SH
  1. Position the wheelhouse liner panel.
  2. Install the upper outer bolt.
  3. Install the upper center bolts.
  4. Position the lower front corner of the wheelhouse liner panel behind the door opening finish panel and install the attaching bolt.

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the remaining bolts attaching the wheelhouse liner panel to the wheelhouse.

    6. Tighten
    Tighten the rear wheelhouse liner bolts to 1.9 N·m (17 lb in).

  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.