1

Was the park brake diagnostic system check performed?

--

Go to Step 2

Go to Park Brake Diagnostic System Check

1. With the Ignition in the RUN position.
2. Disconnect the Park Brake Switch connector.
3. Connect a jumper wire between the Park Brake Switch connector and ground.

Does the Brake indicator light illuminate?

--

Go to Step 3

Go to Step 4

Adjust or replace the Park Brake Switch. Refer to Parking Brake Indicator Switch Replacement .

Is the repair complete?

--

Go to Park Brake Diagnostic System Check

--

1. Disconnect C1 of the ABS Control Module.
2. Remove the IP Cluster.
3. Connect a J 39200 (continuity) between cavity 17 of the IP Cluster connector and ground

Is continuity present?

--

Go to Step 5

Go to Step 6

Locate and repair the short to ground in CKT 33 (TAN/WHT) between the IP Cluster, ABS Control Module and the Park Brake Switch. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Park Brake Diagnostic System Check

--

Replace the Instrument Cluster. Refer to Instrument Cluster Replacement in Instrument Panel, Gauges and Console.

Is the repair complete?

--

Go to Park Brake Diagnostic System Check

--