Tools Required

1. Remove the steering column tilt head. Refer to Steering Column Tilt Head - Off Vehicle .



2. Remove the gray (1) connector.



3. Remove the 3 screws (1) from the signal switch housing assembly (2).



4. Depress the tabs (1) on the windshield wiper and washer switch assembly (2) and remove from the signal switch housing assembly (3).

Tools Required

1. Insert the windshield wiper and washer switch assembly (2) into the signal switch housing assembly (3). Allow the tabs (1) to fall in place.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the signal switch housing assembly (2) and secure by using the 3 pan head tapping screws (1).

Tighten
Tighten the screws to 7 N·m (62 lb in).




3. Install the gray (1) connector.
4. Install the steering column tilt head. Refer to Steering Column Tilt Head - Off Vehicle .