Tools Required

Notice
Before performing the following procedures, check the fused jumper assembly for burnt 2 amp fuses.

1. Remove the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement - Off Vehicle .



2. Remove the black inflatable restraint steering wheel module coil connector (2) from the fused jumper assembly connector (1).



3. Remove the retaining ring (3).
4. Remove the inflatable restraint steering wheel module coil (2).
5. Remove the wave washer (1).

Tools Required

1. Install the wave washer (1) to the race and upper shaft assembly (2).



2. To install the inflatable restraint steering wheel module coil:

•	Make sure the wheels are straight ahead.

•	Align the block tooth on the race and upper shaft assembly (1) to the 12 o'clock position.




3. The new inflatable restraint steering wheel module coil will be precentered. Pull the tab and remove. Do not depress the tab (1) on the back of the inflatable restraint steering wheel module coil.



4. Align the inflatable restraint steering wheel module coil (1) with the horn tower on the turn signal cancel cam assembly (2).




Important: The retaining ring (1) must seat securely on the groove of the race and upper shaft assembly (2).

5. Install the retaining ring (1).



6. Install the black inflatable restraint steering wheel module coil connector (2) to the fused jumper assembly connector (1).
7. Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement - Off Vehicle .