Step
| Action
| Normal Result(s)
| Abnormal Result(s)*
|
1
|
- Place the mirror select switch in the LH OUTSIDE MIRROR position.
- Operate the power mirror switch in each of the following directions:
| The
LH outside mirror moves as commanded.
|
|
2
|
- Place the mirror select switch in the RH OUTSIDE MIRROR position.
- Operate the power mirror switch in each of the following directions:
| The
RH outside mirror moves as commanded.
|
|
3
| Press the Memory 1 button.
|
• | A single beep is heard. |
• | Both mirrors move to the positions programmed for Driver 1. |
|
|
4
| Press the Memory 2 button.
|
• | A single beep is heard. |
• | Both mirrors move to the positions programmed for Driver 2. |
|
|
5
| Press the Exit button.
|
• | A single beep is heard. |
• | The left seat moves to the exit position programmed for the last
driver to perform a memory record or a recall function. |
|
|
6
|
- Set the ignition switch to RUN.
- Set the shift selector to REVERSE.
| The
right outside mirror tilts down 7 degrees or to the end of the travel.
|
Parallel Park Mode Inoperative
|
7
| During suitable environmental conditions, complete the following steps:
- Turn on the rear defogger.
- Wait approximately 10 minutes in order to see if the mirrors
clear of frost or mist.
| The
mirrors heat up and clear of mist or frost.
|
|
* Refer to the appropriate symptom diagnostic table for
the applicable abnormal result.
|