GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2001 🢒 Catera 🢒 Body and Accessories 🢒 Horns 🢒 Steering Wheel Inflatable Restraint Module Replacement

Removal Procedure

    Object Number: 210514 Size: SH

    Caution: When you are carrying an undeployed inflator module:

       • Do not carry the inflator module by the wires or connector on the inflator module
       • Make sure the bag opening points away from you
    When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

  1. Disable the SIR system. Refer to Disabling the SIR System .
  2. Remove the 2 TORX® screws from the back of the steering wheel.
  3. Remove the inflatable restraint module from the steering wheel.
  4. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
  5. Remove the connector position assurance (CPA) from the yellow 2-way connector on the steering wheel module.
  6. Disconnect the yellow 2-way connector from the steering wheel module.

Installation Procedure

    Object Number: 210514 Size: SH
  1. Connect the yellow 2-way connector to the steering wheel module.
  2. Install the CPA.
  3. Install the steering wheel module.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the 2 TORX® screws to the back of the steering wheel.

    5. Tighten
    Tighten the screws to 8 N·m (72 lb in).

  5. Enable the SIR system. Refer to Enabling the SIR System .