Removal Procedure
- Disable the SIR system.
Refer to
Disabling the SIR System
in SIR.
- Remove the screw caps from upper steering column.
- Remove the screws from upper steering column.
- Remove the upper steering column cover.
- Remove the steering wheel
tilt lever. Refer to
Tilt Lever Replacement - On Vehicle
- Remove the rubber protective cover from lock cylinder.
- Remove the screws from lower steering column cover.
- Remove the lower steering column cover.
- Depress the tabs to release
windshield washer switch from the steering column.
- Disconnect the windshield
washer switch electrical connector.
Installation Procedure
- Connect the electrical
connector to turn signal switch.
- Install the turn signal
switch to steering column making sure tabs engage.
- Install the lower steering
column cover.
- Install the screws to lower steering column cover.
- Install the rubber protective cover to ignition lock cylinder.
- Install the steering wheel
tilt lever. Refer to
Tilt Lever Replacement - On Vehicle
- Install the upper steering column cover.
- Install the screws to upper steering column.
- Install the screw caps to upper steering column.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.