Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the Headlight System Check?
| --
| Go to
Step 2
| Go to
Headlight System Check
|
2
|
- Disconnect the instrument cluster connector.
- Disconnect the BCM connector C1.
- Use the DMM to measure the resistance between terminal 9 of the
instrument cluster connector and terminal C08 of the BCM connector C2.
Is the measured resistance less than the specified value?
| 5 ohms
| Go to
Step 4
| Go to
Step 3
|
3
|
- Locate an open or a high resistance in circuit M75.
- Repair the open or the high resistance in circuit M75.
Is the repair complete?
| --
| Go to
Step
5
| --
|
4
|
- Inspect the high beam indicator bulb.
- If the high beam indicator bulb is OK, replace the instrument
cluster. Refer to
Instrument Cluster Indicator Lamp Replacement
in Instrument Panel, Gauges and Console.
Is the replacement complete?
| --
| Go to
Step
5
| --
|
5
|
- Connect all connectors and components that were disconnected.
- Verify that the high beam indicator operates properly.
Does the high beam indicator operate properly?
| --
| Go to
Headlight System Check
| Go to
Step 1
|
