Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Wiper/Washer System Check performed?
| --
| Go to
Step 2
| Go to
Wiper/Washer System Check
|
2
|
- Disconnect the windshield wiper/washer switch.
- Use a DMM in order to measure the resistance between terminal 53A
and terminal W of the windshield wiper/washer switch while holding
the mist switch in the ON position.
Is the measured resistance within the specified range?
| Less than 5 ohms
| Go to
Step 3
| Go to
Step 4
|
3
|
- Locate an open or a high resistance in CKT FA4.
- Repair the open or the high resistance in CKT FA4.
Is the repair complete?
| --
| Go to
Step 5
| --
|
4
| Replace the windshield wiper/washer switch. Refer to
Windshield Wiper and Washer Switch Replacement - On Vehicle
in Steering.
Is the repair complete?
| --
| Go to
Step 5
| --
|
5
|
- Reconnect all of the components and the connectors that were disconnected.
- Verify that the windshield washer pump and the windshield wipers
operate properly when the windshield wiper/washer switch is in the MIST position.
Do the windshield washer pump and the windshield wipers operate properly?
| --
| Go to
Wiper/Washer System Check
| Go to
Step 1
|
