Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Wiper/Washer System Check performed?
| --
| Go to
Step 2
| Go to
Wiper/Washer System Check
|
2
|
- Disconnect the windshield wiper motor connector.
- Turn the ignition switch to the ON position.
- Turn the windshield wiper/washer switch to the LOW position.
- Use a DMM in order to measure the voltage between terminal A
of the windshield wiper motor connector and ground.
Does the voltage measure at the specified value?
| B+
| Go to
Step 4
| Go to
Step 3
|
3
|
- Locate an open or a high resistance in CKT B7.
- Repair the open or the high resistance in CKT B7.
- If CKT B7 is OK, replace the windshield wiper/washer switch.
Refer to
Windshield Wiper and Washer Switch Replacement - On Vehicle
in Steering.
Is the repair complete?
| --
| Go to
Step 5
| --
|
4
|
- Check for a faulty connection at terminal A of the windshield
wiper motor connector.
- If the connection is OK, replace the windshield wiper motor. Refer
to
Windshield Wiper Motor Replacement
.
Is the repair complete?
| --
| Go to
Step 5
| --
|
5
|
- Reconnect all of the connectors and the components that were disconnected.
- Verify that the windshield wipers operate properly at LOW speed.
Do the windshield wipers operate properly at LOW speed?
| --
| Go to
Wiper/Washer System Check
| Go to
Step 1
|
