Accident With or Without Air Bag Deployment -- Component Inspections
CAUTION: Proper operation of the Supplemental Inflatable Restraint (SIR) sensing
system requires that any repairs to the vehicle structure return the vehicle
structure to the original production configuration. Not properly repairing
the vehicle structure could cause non-deployment of the air bag(s) in a frontal
collision or deployment of the air bag(s) for conditions less severe than
intended.
CAUTION: Proper operation of the Supplemental Inflatable Restraint (SIR) sensing
system requires that any repairs to the vehicle structure return the vehicle
structure to the original production configuration. Not properly repairing
the vehicle structure could cause non-deployment of the side impact air bag(s)
in a side impact collision or deployment of the side impact air
bag(s) for conditions less severe than intended.
After any collision, inspect the following components
as indicated. If you detect any damage, replace the component. If you detect
any damage to the mounting points or mounting hardware, repair the component
or replace the hardware as needed.
| • | The IP knee bolsters and mounting points - Inspect the knee
bolsters for bending, twisting, buckling, or any other type of damage. |
| • | The IP brackets, braces, etc. - Inspect for bending, twisting,
buckling, or any other type of damage. |
| • | The IP cross car beam - Inspect for bending, twisting, buckling,
or any other type of damage. |
| • | The IP mounting points and brackets - Inspect for bending,
twisting, buckling, or any other type of damage. |
| • | The seats and seat mounting points - Inspect for bending,
twisting, buckling, or any other type of damage. |
Accident With Frontal Air Bag Deployment -- Component Replacement
and Inspections
After a collision involving air bag deployment, replace the following
components.
| • | Inflatable restraint IP module |
| • | Inflatable restraint steering wheel module |
| • | Inflatable restraint sensing and diagnostic module (SDM) |
| • | Inflatable restraint side impact module (seat air bag) if deployed |
Perform additional inspections on the following components.
| • | Steering wheel module coil and the coil wiring pigtail - Inspect
for melting, scorching, or other damage due to excessive heat. |
| • | Mounting points or mounting hardware for the IP module, steering
wheel module, and SDM - Inspect for any damage and repair or replace each
component as needed. |
Accident With Side Air Bag Deployment -- Component Replacement
and Inspections
After a collision involving side air bag deployment, replace the following
components.
| • | Inflatable restraint side impact sensors (SIS) (Left/Right), on
the side of the impact. |
| • | Inflatable restraint side impact module (LF/RF), on the side of
the impact. |
| • | Inflatable restraint sensing and diagnostic module (SDM). |
Perform additional inspections on the following components.
| • | Mounting points or mounting hardware for the SIS, and side impact
module (LF/RF) on the side of impact - Inspect for any damage and repair or
replace each component as needed. |
| • | Mounting points or mounting hardware for the SDM - Inspect for
any damage and repair or replace each component as needed. |
Sensor Replacement Guidelines
The SIR/side air bag sensor replacement policy requires replacing sensors
in the area of accident damage. The area of accident damage is defined as
the portion of the vehicle which is crushed, bent, or damaged due to
a collision. An example of this would be a moderate collision where the
front of the vehicle impacts a tree, if the vehicle has an SIR sensor
mounted forward of the radiator, replace the SIR sensor.
| • | Replace the sensor whether or not the air bags have deployed. |
| • | Replace the sensor even if the sensor appears to be undamaged. |
Sensor damage which is not visible, such as slight bending of the mounting
bracket or cuts in the wire insulation, can cause improper operation of the
SIR/side air bag sensing system. Do not try to determine whether the
sensor is undamaged. Replace the sensor. Also, if you follow a Diagnostic
Trouble Code (DTC) table and a malfunctioning sensor is indicated, replace
the sensor.
