DEFINITION: The right front, the right rear, or the left rear power window is inoperative at the selected door switch, but operates properly with the driver door window switch.

Did you perform the Power Windows System Check?

--

Go to Step 2

Go to Power Windows System Check

1. Connect a scan tool.
2. Select DATA from the driver door module (DDM) data list.
3. Operate the door window switch to the UP and the DOWN positions.

Does the scan tool indicate that the switch operates properly?

--

Go to Step 5

Go to Step 3

1. Disconnect the inoperative power window switch.
2. Measure the resistance between the window switch terminal 2 and terminal 4 while pressing the switch to the UP position.
3. Measure the resistance between the window switch terminal 1 and terminal 4 while pressing the switch to the DOWN position.

Is the resistance within the specified range for both measurements?

0-5 ohms

Go to Step 5

Go to Step 4

Replace the power window switch. Refer to Front Side Door Window Switch Replacement .

Did you complete the repair?

--

Go to Power Windows System Check

--

1. Disconnect the door module connector at the inoperative door.
2. Measure the resistance between the window switch harness connector terminal 4 and the appropriate door module connector terminal:

•	Right front door - terminal 10

•	Right rear door - terminal A1

•	Left rear door - terminal B9

Is the resistance within the specified range?

0-5 ohms

Go to Step 7

Go to Step 6

Repair an open in the appropriate circuit. Refer to Wiring Repairs in Wiring Systems:

Did you complete the repair?

--

Go to Power Windows System Check

--

Measure the resistance between the window switch harness connector terminal 1 and the appropriate door module harness connector terminal:

Is the resistance within the specified range?

0-5 ohms

Go to Step 9

Go to Step 8

Repair an open in the appropriate circuit. Refer to Wiring Repairs in Wiring Systems:

Did you complete the repair?

--

Go to Power Windows System Check

--

Measure the resistance between the window switch harness connector terminal 2 and the appropriate door module harness connector terminal:

Is the resistance within the specified range?

0-5 ohms

Go to Step 11

Go to Step 10

Repair an open in the appropriate circuit. Refer to Wiring Repairs in Wiring Systems:

Did you complete the repair?

--

Go to Power Windows System Check

--

Replace the door module at the inoperative door.

Refer to one of the following procedures:

Did you complete the repair?

--

Go to Power Windows System Check

--