Removal Procedure
- Apply tape to the following locations in order to prevent any paint damage during this procedure:
- Remove the hood hinge cover (1).
- Remove the 2 assist rods (2).
- Remove the 2 hinge pivot bolts (3).
- Remove the hood (1) with the aid of an assistant.
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
| • | The edges of the fenders |
| • | The hood (1) |
Installation Procedure
- Place the hood (1) into position with the aid of an assistant.
- Install the hinge pivot bolts (3) in order to retain the hood (1).
- Install the assist rods (2).
- Install the hood hinge cover (1).
- Align the hood as needed. Refer to Hood Adjustment .
- Touch up any exposed or unpainted surface after the hood replacement.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 11 N·m (93 lb in).
