GM Service Manual Online
For 1990-2009 cars only

Fore/Aft Adjustment Procedure

    Important: Oversized holes in the hinge provide fore and aft adjustment of the hood.

  1. Loosen the hood attaching bolts at the upper hood hinge.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Tighten the upper hood hinge attaching bolts on both sides.
  4. Tighten
    Tighten the bolts to 11 N·m (93 lb in).

Up/Down Adjustment


    Object Number: 256021  Size: SH
  1. Adjust the rubber bumpers (1) in order to align the hood panel flush with the fenders.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Make additional up/down adjustments as needed, at the hinge pivot bolts.
  4. Tighten
    Tighten the pivot bolts to 11 N·m (93 lb in).

  5. Adjust the hood latch assembly as required.
  6. After performing the hood alignment, ensure that sufficient load remains on the hood stop bumpers in order to eliminate hood flutter.
  7. Lower the hood latch assembly an additional 3.175 mm (1/8 in) for front flutter.
  8. Adjust the rubber bumpers (1). Ensure that the hood panel is flush with the fenders.