Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the IP Cluster Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Is any DTC set? | -- | Go to the appropriate DTC Diagnostic Table | Go to Step 3 |
3 |
Does the odo/trip switch on the scan tool cycle on to off when the ODO/TRIP button is pressed? | -- | Go to Step 11 | Go to Step 4 |
4 |
Is the resistance within the specified range? | 0-5 ohms | Go to Step 5 | Go to Step 10 |
5 | Does the ODO/TRIP button work correctly? | -- | Go to Step 6 | Go to Step 8 |
6 | Test CKT 1326 for an open. Is CKT 1326 open? | -- | Go to Step 7 | Go to Step 8 |
7 | Repair the open in CKT 1326. Is the repair complete? | -- | -- | |
8 | Check CKT 350 for an open. Is CKT 350 open? | -- | Go to Step 9 | Go to Step 10 |
9 | Repair the open in CKT 350. Is the repair complete? | -- | -- | |
10 | Replace the DIC switch assembly. Refer to Driver Information Display Switch Replacement . Is the repair complete? | -- | -- | |
11 | Replace the instrument cluster. Refer to Instrument Cluster Replacement . Is the repair complete? | -- | -- |
