GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 1998 🢒 Park Avenue 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Driver Information Display Switch Replacement

Removal Procedure

    Object Number: 262567 Size: SH
  1. Remove the IP cluster trim plate (1). Refer to Instrument Panel Trim Panel Replacement - Left Side .
  2. Disconnect the electrical connector.
  3. Remove the fasteners (2) from the driver information switch (3).
  4. Remove the driver information switch (3).

Installation Procedure

    Object Number: 262567 Size: SH
  1. Install the driver information switch (3) to the IP cluster trim plate (1).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the fasteners (2) to the drivers information switch.

    3. Tighten
    Tighten 2 N·m (18 lb in).

  3. Connect the electrical connector.
  4. Install the IP cluster trim plate (1). Refer to Instrument Panel Trim Panel Replacement - Left Side .