DEFINITION: The high and low side pressures may be normal or slightly less than normal.

Were you sent here from the A/C System Performance Test?

--

Go to Step 2

Go to Air Conditioning (A/C) System Performance Test

Refer to the instrument panel outlet air temperatures recorded during the A/C system performance test.

Does the discharge air temperature between the right and left center I/P outlets vary by more than 1-2°C (2-3°F)?

--

Go to Step 7

Go to Step 3

Did the customer mention that the A/C system output temperatures are good at first, but then turn warm during extended drives?

--

Go to Step 4

Go to Step 5

Increase engine speed to 2,000 RPM.

During extended operation of the A/C system, does the low side pressure decrease, possibly accompanied by heavy frost on the liquid line between the expansion device and the evaporator?

--

Go to Air Conditioning (A/C) Diagnostics - Pressure Zone D

Go to Step 5

1. Refer to the pressures recorded during the A/C system performance test.
2. Inspect for the following conditions:

Caution: Avoid contact with moving parts and hot surfaces while working around a running engine in order to prevent physical injury.

•	The high side pressure slightly greater than the specified pressure ranges but still within Zone A on the A/C Pressure-Zone Classification Chart in the A/C System Performance Test. Refer to Air Conditioning (A/C) System Performance Test .

•	The discharge line is hot.

•	The suction line is cool.

Do the listed conditions exist?

--

Go to Step 7

Go to Step 6

Refer to the pressures recorded during the A/C system performance test.

Inspect for the following conditions:

Do the listed conditions exist?

--

Go to Step 8

Go to Too Hot in Vehicle in HVAC Systems - Manual

OR

Go to Too Hot in Vehicle in HVAC Systems - Automatic

The A/C system may be undercharged.

1. Leak test A/C system. Refer to Leak Testing .
2. Recharge the A/C system to specifications. Refer to Refrigerant Recovery and Recharging .

Is the action complete?

--

Go to Step 14

--

The A/C system may be contaminated.

View the J 43600 information screen for detection of foreign gases in the A/C system.

Do foreign gases exist?

--

Go to Step 9

Go to Step 10

1. Evacuate the A/C system to a scavenging tank. Refer to Refrigerant Recovery and Recharging .
2. Recharge the A/C system to specifications.

Is the action complete?

--

Go to Step 14

--

The A/C system may contain too much moisture or air.

1. Evacuate and recharge the A/C system to specifications. Refer to Refrigerant Recovery and Recharging .
2. Operate the A/C system and check the outlet air temperatures. Refer to Air Conditioning (A/C) System Performance Test .

Are the instrument panel outlet air temperatures within the specified ranges of the A/C Performance Test Table?

--

Go to Step 15

Go to Step 11

The A/C system may contain too much refrigerant oil.

1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .
2. Remove the accumulator. Refer to Air Conditioning Accumulator Replacement .
3. Drain and measure the refrigerant oil from the accumulator.

Was more than the specified amount of refrigerant oil drained from the accumulator?

148 ml (5 oz)

Go to Step 12

Go to Step 13

1. Reinstall the accumulator. Refer to Air Conditioning Accumulator Replacement .
2. Flush the A/C system. Refer to Flushing .
3. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .

Are the actions complete?

--

Go to Step 14

--

1. Add the specified amount of refrigerant oil to the accumulator. Refer to Refrigerant System Capacities .
2. Install the accumulator. Refer to Air Conditioning Accumulator Replacement .
3. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .

Are the actions complete?

--

Go to Step 14

--

1. Record the low and high side pressures and the instrument panel outlet air temperature.
2. Compare the instrument panel outlet air temperatures to those listed in the A/C System Performance Chart. Refer to Air Conditioning (A/C) System Performance Test .

Are the high and low side pressures and instrument panel outlet air temperatures within specifications?

--

Go to Step 15

Go to Air Conditioning (A/C) System Performance Test

Operate the system in order to verify the repair.

Did you find and correct the condition?

--

System OK

Go to Symptoms - HVAC Systems - Manual in HVAC Systems-Manual

OR

Go to Symptoms - HVAC Systems - Automatic in HVAC Systems - Automatic