The body control module (BCM) monitors the cruise control indicator switch. When the cruise on/off switch is pressed ON, the cruise control switch is closed and the signal circuit is low. When the cruise on/off switch is pressed OFF, the cruise control switch is open and the signal circuit is high.

Schematic Reference

Cruise Control Schematics

Connector End View Reference

Cruise Control Connector End Views

Description and Operation

Cruise Control Description and Operation

Electrical Information Reference

Scan Tool Reference

1. Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
2. Disconnect the harness connector at the steering wheel controls switch - left.
3. Cruise switch ON, test for less than infinite resistance between the steering wheel control supply voltage terminal 1 and the cruise control indicator dimming signal circuit terminal 9 at the terminals of the steering wheel controls switch - left.

⇒	If the resistance measured is infinite, replace the steering wheel controls switch - left.

4. Igniton OFF, verify that a test lamp illuminates between B+ and the cruise control indicator dimming signal circuit terminal 9.

⇒	If the test lamp does not illuminate, test the cruise control indicator dimming signal circuit for an open/high resistance.

5. If all circuits test normal, replace the BCM.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.