- Note the original position of the liftgate latch striker.
- Remove the striker.
- Loosen the hinge-to-roof panel bolts for forward or rearward adjustments.
- If Adjusting hinge to roof panel Bolts. Lower Rear And Headliner if as needed.
- Loosen the liftgate-to-hinge bolts for up and down adjustment.
- Move the liftgate within the liftgate opening to achieve the best alignment and operation.
- Install striker to approximately the proper position.
- Adjust the striker to achieve the best operation and alignment of the liftgate.
- Inspect the seals for proper engagement.
Caution: Refer to Fastener Caution in the Preface section.
- Tighten the bolts when the proper adjustment is achieved.
Tighten
Tighten the bolts to 25 N·m (18 lb ft).