Preliminary Procedure

Clean and Inspect all parts for damage or wear.

1

Manual Shaft Detent Assembly

2

Manual Shift Shaft Detent Spring Retaining Pin

3

Control Valve Body Locator Pin (Qty: 4)

4

Control Valve Body Spacer (w/Gasket) Plate Assembly

5

Valve Body Spacer Retainer (Qty: 2)

6

A/Trans Manual Shift Shaft Position Switch Mounting Bracket Assembly

7

Control Valve Channel Plate Bolt M6 x 20 mm (Qty: 3)

Caution: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
9 N·m (80 lb in)