GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2009 🢒 VUE - AWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Throttle Body Assembly Replacement

Removal Procedure

Caution: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sharp tools may damage the gasket surfaces.


    Object Number: 1883868 Size: SH
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
  2. Disconnect the engine wiring harness electrical connector (3) from the electronic throttle control (ETC) (2).

    3. Object Number: 1775003 Size: SH
  3. Remove the throttle body bolts (9) and nuts (10).
  4. Remove the throttle body (8).
  5. Remove and discard the throttle body gasket (7).

Installation Procedure

    Object Number: 1775003 Size: SH
  1. Install a NEW throttle body gasket (7).
  2. Install the throttle body (8).

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the throttle body bolts (9) and nuts (10).

    4. Tighten
    Tighten the bolts/nuts to 10 N·m (89 lb in).


    Object Number: 1883868 Size: SH
  4. Connect the engine wiring harness electrical connector (3) to the ETC (2).
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
  6. Perform the throttle learn procedure. Refer to Throttle Learn.