For 1990-2009 cars only
Removal Procedure
- Remove the air fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
- Disconnect the engine wiring harness electrical connectors (1) from the ignition coils.
- If removing the #6 ignition coil (1), disconnect the positive crankcase ventilation (PCV) fresh air line (2) from the camshaft cover.
- Remove the ignition coil bolts.
- Remove the ignition coils.
Installation Procedure
- Install the ignition coils.
- Install the ignition coil bolts. Tighten the bolts to 10 N·m (89 lb in).
- If the #6 ignition coil (1) was removed, connect the PCV fresh air line (2) to the camshaft cover.
- Connect the engine wiring harness electrical connectors (1) to the ignition coils.
- Install the air fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
Caution: Refer to Fastener Caution in the Preface section.
