Removal Procedure
- Disable the SIR system. Refer to
Disabling the SIR System
in
SIR.
- Remove the instrument panel.
- Remove the screws and the center air outlet duct.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the center air outlet duct and screws.
Tighten
Tighten the center air outlet duct screws to 10 N·m (89 lb in).
Important: Make sure that the right plastic mounting tab is between the knee beam and the
mounting bracket.
- Install the instrument panel.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.