Preliminary Procedures

1. Open the hood.
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Disengage the connector positive assurance (CPA) clip from the wiper motor electrical connector.
4. Disconnect the wiper motor electrical connector from the wiper motor.

1

Windshield Washer System Module Bolt (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tip

1. Install the driver side bolt first.
2. Install the passenger side bolt second.
3. Install the center bolt third.

Tighten
9 N·m (80 lb in)

2

Windshield Washer System Module Assembly