Tools Required

1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.0L (L81).



2. Remove the pulley from the power steering pump. Refer to Power Steering Pump Pulley Replacement .



3. Disconnect the power steering pressure hose from the power steering pump.
4. Disconnect the power steering return hose from the power steering pump.



5. Remove the power steering pump to bracket bolts.
6. Remove the power steering pump from the vehicle.



7. Using the SA9162C-2 , remove the power steering pulley hub from the power steering pump.

1. Using the SA9218NE , install the power steering pulley hub to the power steering pump.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the power steering pump to the power steering pump bracket.

Tighten
Tighten the pump to bracket bolts to 20 N·m (15 lb ft).





Important: Inspect the power steering hose O-ring and replace if necessary.

3. Connect the power steering pressure hose to the power steering pump.

Tighten
Tighten the fitting to 27 N·m (20 lb ft).

4. Connect the power steering return hose to the power steering pump.

Tighten
Tighten the clamp to 2.5 N·m (22 lb in).




5. Install the Power steering pump pulley. Refer to Power Steering Pump Pulley Replacement .



6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.0L (L81).
7. Fill the power steering reservoir and bleed air from the system. Refer to Power Steering System Bleeding .