GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2004 🢒 L300/LW300 🢒 Brakes 🢒 Antilock Brake System 🢒 Brake Pressure Modulator Valve Bracket Replacement

Removal Procedure

    Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

    Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.


    Object Number: 891972 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.

    2. Important: Plug open brake pipes to prevent brake fluid loss and contamination.

  2. Disconnect the brake pipe nuts from the brake pressure modulator valve (BPMV).

    3. Object Number: 891660 Size: SH

    Important: After removing brake pipe nuts, do not excessively pull or bend brake pipes away from master cylinder.

    Important: Plug open brake pipes to prevent brake fluid loss and contamination.

  3. Disconnect the brake pipe nuts from the master cylinder.
  4. Slide out the locking tab and disconnect the electronic brake and traction control module (EBCM) electrical connector.

    5. Object Number: 892480 Size: SH

    Important: Do not bend brake pipes.

  5. Remove the ABS control module mounting nuts and the bracket.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 892480 Size: SH
  1. Position the ABS control assembly into the bracket and tighten the nuts.

    2. Tighten
    Tighten the ABS control assembly-to-bracket nuts to 20 N·m (15 lb ft).


    Object Number: 891660 Size: SH
  2. Position the brake pipes into the master cylinder and tighten the brake pipe nuts.

    3. Tighten
    Tighten the brake pipes-to-master cylinder to 18 N·m (13 lb ft).


    Object Number: 891972 Size: SH
  3. Position the brake pipes into the ABS control assembly and tighten the brake pipe nuts.

    4. Tighten
    Tighten the brake pipes-to-master cylinder to 18 N·m (13 lb ft).


    Object Number: 892016 Size: SH

    Important: Ensure that all the electrical connections are fully seated and the latches are engaged.

    Important: If the EBCM was replaced, make sure to program the correct engine and transaxle options in the EBCM. Refer to option bit configuration with Scan tools.

  4. Install the electrical connector to the ABS control assembly.
  5. Install the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  6. Fill the brake fluid reservoir with clean brake fluid up to the "MAX" mark on the reservoir.

    7. Important: It is not required or recommended to bleed the ABS controller. Automated bleeding of the ABS controller may induce air into the system.

  7. Bleed the brakes. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.