- Remove the high mounted stop lamp. Refer to
High Mount Stop Lamp Replacement
in Lighting Systems.
- Remove the lift gate trim panel. Refer to
Liftgate Trim Panel Replacement
in
Body Rear End.
- Remove the rear wiper motor. Refer to
Rear Window Wiper Motor Replacement
in Wiper/Washer
Systems.
Caution: Always wear heavy gloves and safety glasses when handling glass to minimize
the risk of injury.
Notice: Care must be taken to avoid damaging paint around glass during removal.
- Disconnect the
electrical connectors from the rear window defogger bus bars. Position the electrical
connectors so not to damage the wiring/connectors when using the urethane power removal
tool.
Important: Before cutting out a stationary window, apply a double layer of masking tape
around the perimeter of the painted surfaces and inner trim.
- Apply two 15 cm (6 in) pieces of duct tape to the top and bottom
of the glass to prevent it from falling out when the urethane adhesive is cut.
Caution: When using power tools that may create smoke when cutting urethane sealant,
work should be done in a well ventilated area and/or with a NIOSH/MSHA Approved air
supplied respirator to prevent possible harmful exposure.
When the urethane adhesive is heated enough to give off smoke, high levels of
methylene diisocyanate (MDI) may be present.
Unprotected exposure to methylene diisocyanate (MDI) may result in severe, chronic,
debilitating respiratory problems.
- From the inside
of the lift gate, cut the urethane around the glass using a J 39032
.
- With the aid of an assistant, remove the lift gate window from the opening.
