Coolant Gauge Position: The scan tool displays 0-100%. The BCM receives a serial data message from the ECM regarding the engine coolant temperature and converts the data to percentage.

Displayed Odometer: The scan tool displays the vehicle odometer.

Driver Door Switch: The scan tool displays Low or High. The state of the driver door switch as commanded by the BCM.

ECT: The scan tool displays -40 to +151°C (-40 to +304°F). The ECM monitors the voltage at the signal circuit of the engine coolant temperature sensor. The voltage is inversely proportional to the engine coolant temperature.

Engine Oil Life Left: The scan tool displays 0-100%. The ECM calculates the remaining engine oil life.

Engine Oil Life Remaining: the scan tool displays 0 - 100%. The PCM calculates the remaining engine oil life.

Engine Speed: The scan tool displays 0-9999 RPM. Engine speed is computed by the ECM/PCM. It should remain close to desired idle under various engine loads with the engine idling.

Fuel Gauge Position: The scan tool displays 0-100%. The BCM calculates the amount of fuel remaining in the tank based on the serial data messages from the ECM/PCM regarding fuel level.

Fuel Level: The scan tool displays the amount of fuel left in Gallons or Liters. The ECM calculates the amount of fuel remaining in the tank based on the input from the fuel level sensor.

Fuel Level: The scan tool displays the amount of fuel left in percentage. The PCM calculates the amount of fuel remaining in the tank based on the input from the fuel level sensor.

Fuel Level: The scan tool displays the state of the fuel level in Volts. The ECM monitors the signal circuit of the fuel level sensor and displays the current voltage.

Key in Ignition: The scan tool displays Yes or No. The state of the key in ignition switch as commanded by the BCM.

Low Brake Fluid: The scan tool displays Yes or No. The state of the brake fluid level switch as commanded by the BCM.

Low Coolant: The scan tool displays Yes or No. The state of the coolant level switch as commanded by the BCM.

Module Type: The scan tool displays Domestic or Export. The type of IPC installed in the vehicle.

Module Type-Carline: The scan tool displays a numeric value. The type of IPC installed in the vehicle.

Module Type-Export: The scan tool displays Yes or No. The type of IPC installed in the vehicle.

Part Number: The scan tool displays a numeric value. The part number of the IPC installed in the vehicle.

Pass Door Switches: The scan tool displays Low or High. The state of the passenger door switches as monitored by the BCM.

Software Date-Day: The scan tool displays the day the software was created for the IPC installed in the vehicle.

Software Date-Month: The scan tool displays the month the software was created for the IPC installed in the vehicle.

Software Date-Year: The scan tool displays the year the software was created for the IPC installed in the vehicle.

Software ID: The scan tool displays a numeric value. The identification of the IPC software installed in the vehicle.

Vehicle Speed: The scan tool displays 0-255 km/h (0-155 mph). The ECM/PCM monitors the signal circuit of the vehicle speed sensor.