Caution: Refer to Battery Disconnect Caution in the Preface section.

Important: When replacing the control unit, before removing the control unit, carry out a "Reset" using Tech 2. For reprogramming procedures, refer to Control Module References .

1. Disconnect the battery.
2. Remove the steering wheel. Refer to Steering Wheel Replacement .



3. Remove the lower steering column panel.

•	Remove the 5 bolts (arrows).

•	Remove the ignition lock panel (1).




4. Remove the column integration module (CIM).

•	Remove the 3 bolts (1).

•	Disconnect the wiring harness holder (arrow).

•	Release the wiring harness plug (2) and disconnect.




5. Remove the theft deterrent module.

•	Release the 2 clips (1, 2).

•	Remove the module.

1. Install the theft deterrent module.

Install the 2 clips.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the CIM.

•	Connect and lock the wiring harness plug.

•	Connect the wiring harness holder.

Tighten
Tighten the 3 bolts to 2.5 N·m (22 lb in).

3. Install the lower steering column panel.

Install the ignition lock panel.

Tighten
Tighten the 5 screws to 2.5 N·m (22 lb in).

4. Install the steering wheel. Refer to Steering Wheel Replacement .
5. For reprogramming procedures, refer to Control Module References .